30 Levels of NAT Lab #2 – Juniper SRX100s
Well, I had the chance again to play with lots of Firewalls, so I did. A customer had ordered > than 30 SRX100s for clustered branch deployments so I took…
Well, I had the chance again to play with lots of Firewalls, so I did. A customer had ordered > than 30 SRX100s for clustered branch deployments so I took…
Here is the setting for a Junos device to create a user with read only privileges to allow RANCID to work. set system login class RANCID permissions access set system…
The follow post shows output obtained and the upgrade process performed recently on a clients QFabric system. This output was captured updating from 12.2X30 to 12.2X50 Junos release via a…
I was required to check (as this customer did not have a trap collector) which node was active for redundancy group 0 on a SRX cluster. So I thought I…
Have you ever used the VMWare console over a WAN with latency and it enters multiple key strokes into the console and makes using the console super annoying! It makes…
Here is a table of the ports that are used for chassis cluster control link and management ports on Branch SRX devices. The quoted ports are the 'stand alone' non…
Cooper's tip of the moment, ALWAYS backup your Junos configurations. Hate when a customer does not, your router does not have raid (unless it has redundant REs, VC or is…
Juniper is selling QFabric as a bundle. Due to this the install has been templated and will be similar in regards to the control plane and getting the fabric up…
I was lucky enough to be one of the first APAC partner engineers to get my hands on Juniper's new QFabric gigantic scalable switch technology. I have even beat some…
So when I was googiling around looking for working configurations of Junos (EX in this case) AE working with a Cisco vPC (Virtual Port Channel) I could not find any…